Sonarworks includes a specially calibrated measurement microphone with certain products and the mic is also available for purchase separately for $69 (USD). Measuring your speakers in your room requires playing test tones from the SoundID Reference app and capturing the sound with a measurement microphone. However, if you would like to demo SoundID Reference for speaker calibration, you will need to measure your monitors (in your room) and create a calibration profile, or EQ correction curve, for your room. Sonarworks provides a free 21-day trial of their SoundID Reference software, which allows you to audition it with your current headphones and gives you plenty of time to run through all options the headphone calibration software provides. Usually, the cost of the extra devices is minimal compared to the proposed investment and often the extra device is useful in other ways-that extra mic stand or cable will eventually get used. A similar situation exists with needing extra speaker cables to demo a second set of monitors or needing a second mic stand or cable to easily A-B two microphones. The same is true for iLok protected products. Recently I wanted to demo Nuendo software and realized that I needed to purchase a USB e-Licenser in order to run the demo. Do the more expensive tires provide a better ride, better wear or more safety? Often in the studio world, we wish to demo something to see how it works in our particular environment to help us decide on a purchase.ĭemoing an audio product usually requires a bit of investment in time to install software, rewire our setup, or in money to purchase a piece of equipment that facilitates demoing some particular device. When deciding to purchase slightly more expensive tires for our car, we try to determine the benefits vs cost. (*In the event of a claim after the first year, the freight costs for warranty claims to the manufacturer will be borne by the claimant.As thoughtful consumers, we try to make informed choices which often include a cost-benefit analysis as part of our decision-making process.
An Electronic Calibration File (ECF) is generated for each microphone during final testing, and can be downloaded free of charge after product registration. Lightning fast impulse response and linear phase response make the M50 ideal for use with high-quality FFT-based real-time audio system measurement software like SMAART™, SIM™, REW™, Electroacoustics Toolbox™, FuzzMeasure™ and others, as well as for use in PA system alignment and loudspeaker design.Įvery M50 is individually hand-tuned and tested and is delivered with its own printed frequency response chart. With temperature-compensated electronics, the M50 was built to deliver repeatable results no matter what the environment.Ĭompatible With Your Favorite Measurement Software A 140dB SPL rating without distortion and no handling noise. An omnidirectional polar response that is exceptionally consistent. The M50 is a precision engineered 50kHz omnidirectional measurement microphone ideally suited for acoustical measurements including high-end loudspeaker design and quality control, scientific research, measurements of ultrasonic or subsonic transducers, or any application where an extremely accurate free-field measurement microphone is required.Īn ultra wide flat frequency response that extends from 3Hz to 50kHz and is flat throughout the entire spectrum.
0 kommentar(er)
